综放高瓦斯矿井煤层瓦斯涌出量综合预测

为了成功预测竹林山煤矿综放高瓦斯矿井大采高工作面煤层瓦斯涌出量,以主采3号煤层为主要研究对象,针对3号煤层以往开采情况,通过布设测点测量其煤层瓦斯含量和了解相邻矿井瓦斯含量,采用分源预测法、回归法及统计法等预测方法得到了3号煤层瓦斯含量的分布规律,并绘制了3号煤层的瓦斯含量等值线图。对矿井不同生产时期的瓦斯含量进行预测,得到了生产前期、中期及后期采区的最大绝对瓦斯涌出量和最大相对瓦斯涌出量,说明了竹林山煤矿各个时期均属于高瓦斯矿井。     

Study on metamerism degree evaluation based on wavelength sensitive cone weighting algorithm

Metamerism phenomenon can be used in illuminant detection to ensure the accuracy of light source. A method based on Long‐, Middle‐, Short‐ wavelength cones(LMS) weighting algorithm to evaluate metamerism degree is proposed. The chromatic relationship between the degree of metamerism mismatch and the light source is studied. Herein, the consistency between the metameric indices (MIs) and CIE1976 L*a*b* color difference ranking is analyzed by SRCC, KRCC, PLCC and RMSE. A statistically sampling method to obtain practical LMS cone fundamentals to evaluate metamerism degree is employed. The analysis results obtained show that the method based on LMS weighting algorithm has good evaluation ability and stability in simulation experiments and statistically sampling experiments, which are in line with visual characteristics of human. Proposed method meets the requirements of selecting metameric pairs used in light source detection. The analysis results have certain guiding significance.     

Critical current density and mechanical performance of MgB2 superconductors prepared with different magnesium sources

In this study, the critical current density and mechanical performance of MgB₂ superconductors prepared using different magnesium sources (Mg and MgH₂ with 99.9% and 96.5% purities, respectively) were analyzed. When the samples were characterized structurally and electrically, we found that the grain sizes were about 40?nm and transition temperature was around 30?K being lower than the literature. Critical current densities of all samples were calculated using Bean's model and our calculations yielded critical current density values higher than 10⁶?A?cm^?2 in self-field. The highest critical transition temperature value belongs to M800 (Mg with 99.9% purity) sample and when the critical current density and transition temperature values of this sample are considered, this sample appears to have the potential for practical use. Vicker's microhardness measurements were performed and yield stress (Y), elastic modulus (E), brittleness (B_i), ductility (D) and fracture toughness (K_IC) were calculated. All samples exhibited Indentation Size Effect (ISE) and microhardness measurements were compared with some microhardness models with were compatible with ISE behavior.     

Temporal information based GoP adaptation for linear video delivery schemes

An original wireless video transmission scheme called SoftCast has been recently proposed to deal with the issues encountered in conventional wireless video broadcasting systems (e.g. cliff effect). In this paper, we evaluate and optimize the performance of the SoftCast scheme according to the transmitted video content. Precisely, an adaptive coding mechanism based on GoP-size adaptation, which takes into account the temporal information fluctuations of the video, is proposed. This extension denoted Adaptive GoP-size mechanism based on Content and Cut detection for SoftCast (AGCC-SoftCast) significantly improves the performance of the SoftCast scheme. It consists in modifying the GoP-size according to the shot changes and the spatio-temporal characteristics of the transmitted video. When hardware capacities, such as buffer or processor performance are limited, an alternative method based only on the shot changes detection (AGCut-SoftCast) is also proposed. Improvements up to 16 dB for the PSNR and up to 0.55 for the SSIM are observed with the proposed solutions at the cut boundaries. In addition, temporal visual quality fluctuations are reduced under 1dB in average, showing the effectiveness of the proposed methods.     

农村饮用水水源地硝酸盐污染特性研究

农业面源污染是农村饮用水水源地的主要污染因素,其中以硝酸盐污染问题最为突出。根据山东省沂水县域内279处地下水型农村饮用水水源地水质检测结果,本文从取水深度、海拔高程、地形坡度等3个方面对农村饮用水水源地的硝酸盐污染特性进行了系统研究。结果表明,水源地硝酸盐超标率和超标程度均会随着水源地取水深度、海拔高程以及地形坡度的升高而降低。研究结论可为主管部门采取有效的预防和治理措施提供借鉴,并可指导新建水源地的选址。     

基于JJG(闽)1086-2018放射治疗CT模拟定位机X射线辐射源的质控分析

整个精确放疗流程最关键、最基础的一个环节就是定位CT扫描精确程度,做好定位CT的质控关乎整个放疗流程的成败。介绍了JJG(闽)1086-2018放射治疗CT模拟定位机X射线辐射源在检定和质控中的流程和方法,从剂量性能要求、图像成像质量和机器机械精度方面对CT模拟定位机的质量控制做了定量的要求。连续8个月的测试结果表明:CT测量值误差在30HU以内,图像均匀性≤5.0HU,空间分辨力7Lp/cm,低对比度分辨力在对比度为1.0%,0.5%,0.3%时分别≤3.0mm,≤5.0mm,≤6.0mm,达到了规程的要求。CT模拟定位机的图像质量和机械精确程度得到了很好的保障,定位CT的剂量准确,影像参数和位置精确度有规可循。     

Effect of Ni loading on SBA-15 synthesized from palm oil fuel ash waste for hydrogen production via CH4 dry reforming

The successful synthesis of SBA-15 using silica source extracted from palm oil fuel ash (POFA) was proven with the presence of mesostructure characteristics as evidenced by low angle XRD, N₂ adsorption-desorption isotherms and TEM. Different amounts of Ni were loaded on the synthesized SBA-15(POFA) using the impregnation method at 80 °C. The influence of Ni loading over the Ni/SBA-15(POFA) physiochemical properties and CO₂ reforming of CH₄ (CRM) were investigated in a stainless steel fixed-bed reactor at 800 °C and atmospheric pressure with 1:1 CO₂:CH₄ volumetric feed composition. An increment in Ni loading on SBA-15(POFA) from 1 to 5 wt% decreased the BET surface area and crystallinity of catalyst as proven by N₂ adsorption–desorption and XRD analysis. The catalytic performance of CRM followed the sequence of 3 wt% > 5 wt% > 2 wt% > 1 wt% -Ni/SBA-15(POFA). This result was owing to the even distribution of Ni and good Ni–O–Si interaction of 3 wt% Ni/SBA-15(POFA) as proved by TEM, FTIR and XPS. Lowest H₂/CO ratio and catalyst activity and stability of 1 wt% Ni/SBA-15(POFA) were due to the weaker Ni–O–Si interaction and small amount of basic sites that favor the reverse water gas shift (RWGS) reaction and carbon formation. The recent finding indicates that a quantity as small as 3 wt% Ni loaded onto SBA-15(POFA) could elicit outstanding catalytic performance in CRM, which was comparable with 10 wt% Ni loading catalysts reported in literature.     

Second order velocity slip and thermal jump of Cu–water nanofluid over a cone in the presence of nonlinear radiation and nonuniform heat source/sink using homotopy analysis method

The purpose of the present paper is to explore the second order slip effects on nanofluid flow over a vertical cone. The effects of nonlinear thermal radiation and nonuniform heat source/sink are also taken into account. Water with copper nanoparticles is used as nanofluid in this investigation. The governing partial differential equations for the flow are converted into ordinary differential equations by using transformations and then are solved using homotopy analysis method. The influence of various important parameters on velocity, temperature, skin‐friction, and Nusselt number are presented through graphs. Results indicate that the velocity and magnitude of skin friction decrease with a rise in first and second order velocity slips. A raise in either first or second order temperature jump causes a fall in temperature. Nonlinear radiation increases the more rapidly when compared to the linear radiation case.     

Preparation and electrocatalytic properties of spinel CoxFe3-xO4 nanoparticles

The catalysts are often used in fuel cells and metal-air batteries to speed up electrochemical reactions. In this study, we prepared CoFe₂O₄ nanoparticles with mainly inverse spinel structure and FeCo₂O₄ nanoparticles with mainly spinel structure as bifunctional catalysts by hydrothermal method. After annealing at 350 °C, pure CoFe₂O₄ and FeCo₂O₄ nanoparticles with uniform size distribution have been obtained. The CoFe₂O₄ nanoparticles showed high current density of 5.5 mA/cm² at −0.8 V in the ORR test. It's low Tafel slope of 83.0 mV/dec further confirmed the excellent ORR catalytic properties of CoFe₂O₄ nanoparticles. Furthermore, the CoFe₂O₄ nanoparticles also showed good OER properties with satisfied current density of 35.7 mV/cm² at l.0 V and low OER Tafel slope of 71.0 mV/dec. Both the ORR and OER properties of CoFe₂O₄ nanoparticles showed good time stability which were compared with FeCo₂O₄ nanoparticles. These results indicated that CoFe₂O₄ nanoparticles with mainly inverse spinel structure had better electrocatalytic performance than FeCo₂O₄ nanoparticles with mainly spinel structure. The CoFe₂O₄ nanoparticles with mainly inverse spinel structure show a significant potential application in rechargeable battery.